Wireless router stuck on validating identity

17-May-2017 13:41

Click on Properties once you select the wireless network that is having problems.

Click on the Authentication tab and now uncheck the Enable IEEE 802.1x authentication for this network box.

The below guide has been tested on MS Windows XP Professional and is based on Windows' default wireless configuration tool (Wireless Zero Configuration).

Ok so I setup the router to only transmit wireless N and to use WPA2 only.The weird part is that I was using WPA TKIP with the passphrase and it was working fine.I moved the selection tab to WPA2 only and keep the rest the same and no luck. Ok so I setup the router to only transmit wireless N and to use WPA2 only.In a few simple steps you can bypass Windows Validation, and the resulting "Limited or No Connectivity" issue on an encrypted connection.In the next window click on the "Authentication" tab, Make sure "Enable IEEE 802.1x...." checkbox is UN-Checked, the rest of this window should be greyed out.

Ok so I setup the router to only transmit wireless N and to use WPA2 only.

The weird part is that I was using WPA TKIP with the passphrase and it was working fine.

I moved the selection tab to WPA2 only and keep the rest the same and no luck. Ok so I setup the router to only transmit wireless N and to use WPA2 only.

In a few simple steps you can bypass Windows Validation, and the resulting "Limited or No Connectivity" issue on an encrypted connection.

In the next window click on the "Authentication" tab, Make sure "Enable IEEE 802.1x...." checkbox is UN-Checked, the rest of this window should be greyed out.

If your network is Encrypted go on to step 6 otherwise Click ok and try to connect to your network again.